Specialist UAE contractor across waterproofing, polyurea, repair, and industrial coatings.
View all services →Need technical support? Our specialists will inspect your site and propose the right system.
Request Site InspectionHot-spray pure polyurea waterproofing membranes.
Polyurea coatings are advanced waterproofing and protective coating systems used for roof waterproofing, tank lining, concrete protection, and infrastructure rehabilitation across the UAE. Their seamless application, rapid curing, and durable performance make them suitable for commercial, industrial, infrastructure, defense, offshore, and onshore projects.
Seamless polyurea bridges cracks and movement joints with >800% elongation.
Cures in seconds; assets back in service within hours instead of days.
Aliphatic/hybrid systems resist UV, abrasion and aggressive chemicals.
Monolithic lining for potable water, irrigation, and secondary containment.
Polyurea is a two-component coating made by reacting an isocyanate with a resin blend through high-pressure heated spray equipment. It reacts within seconds to form a seamless, flexible, waterproof and impact-resistant membrane that protects concrete, steel, fibreglass and industrial substrates in demanding environments.
Contains no polyurethane additives — the highest-performing system for waterproofing and protective coatings.
Combines polyurea and polyurethane chemistry to balance flexibility, adhesion and cost.
Used for internal or non-UV-exposed applications where strength and cost-efficiency matter most. Under direct sunlight the surface gradually shifts from grey to a yellow/amber tone — this is purely cosmetic and does not affect waterproofing, elongation or mechanical performance.
Engineered for UV stability and colour retention on exposed surfaces.
100% polyurea, fastest cure, highest performance for waterproofing & lining.
Cost-effective blend for less aggressive exposure.
Best mechanical properties; color shifts under UV.
UV-stable color and gloss retention for exposed surfaces.
No laps, no seams — monolithic across complex geometries.
Walkable in minutes; full service within hours.
Bridges cracks and accommodates structural movement.
Aliphatic topcoats withstand UAE climate and chemicals.
Bonds to concrete, steel and prepared substrates.
Sprayed with GRACO Reactor plural-component plants.
Typical values for engineered polyurea coatings systems. Project-specific values supplied on request.
Shot-blast or grind to SSPC-SP standards; repair defects; prime.
Heat A/B components to ~70°C and pressurize to ~2000 psi.
GRACO Reactor plural-component spray with 1:1 mix ratio.
Holiday/DFT testing, adhesion pull-off, handover dossier.
Two-component pure polyurea is plural-component sprayed at high pressure and temperature, curing on contact to form a seamless, elastomeric waterproof membrane. No joints, no overlaps, no cold-pour failures — just a fully bonded skin that flexes with the substrate.
Photographs from active TEXSA jobsites across the Emirates. Tap any image to enlarge.
Common questions from UAE consultants, clients and contractors. Need something specific? Speak with our technical team.
Related projects
Failure analysis
